Package Contents - i-tec CATRIPLE4KDOCKPD Mode D'emploi

Quick Start / USB-C / USB-A 3.0 3x 4K Docking Station
INTRODUCTION
Thank you for buying the multi-purpose docking station i-tec. Increase your
effectiveness by simple connecting the docking station to your laptop or tablet
with help of a single cable. By this, you will gain access to the connection (it
applies to connection by means of USB-C or Thunderbolt 3; in case of connection
by means of USB 3.0, it is not technologically possible to recharge a laptop via the
docking station), up to three monitors with resolution of 4K, or to two monitors
(one monitor with resolution of 5K/4K and the second one with resolution of 4K).
Five USB 3.0 ports and one USB-C port will enable you to connect all your favorite
accessories. Thanks to this docking station, you will avoid persistent connecting
and disconnecting all devices every time when you take your laptop or tablet
along. The benefit is a possibility of connection of the docking station to USB­A
3.0 or USB-C port of your laptop or tablet. The both possibilities of connection
(a cable of USB-C to C, an adapter of USB-C to A) are a part of the package.
Installation of drivers is automatic from the operation system of Win 10; for other
operation systems, it is necessary to perform a simple installation procedure.
Warning: HDMI port is only operable in case of connection of the docking station
by means of USB-C (connectivity of the docking station via USB 3.0 will provide
operation of two Display Ports, the HDMI port cannot be technologically used).
External power supply exclusively for use with CATRIPLE4KDOCKPD.

PACKAGE CONTENTS

• i-tec USB-C / USB-A 3.0 Docking Station
• Cable USB-C 3.1 to USB-C (100 cm)
• Adapter USB-C 3.1 to USB-A
• Power adapter (output DC: 20.0V/6.75A, DC cable 150 cm)
• Quick Start
SPECIFICATION AND DESCRIPTION
Front panel:
1. On/Off switch for the docking station switching on and off
2. 1x blue LED on after switching-on the docking station
3. 1x green LED on after connection of USB-A or USB-C HDD case
4. 1x USB-C 3.1 port for connection of your USB-C device, is only determined
for data transfer (5 Gbps)
5. 1x USB-A 3.0 port for connection of your existing USB 3.1/3.0/2.0 devices
and data transfer (5 Gbps), supports functions of USB Hot Swapping and
quick recharging according to BC 1.2
6. 1x 3.5 mm Audio out 5.1
7. 1x 3.5 mm Mic in
EN
5