Changing The Displayed Units (Mpa / Psi); Displaying Serial Number - SKF THGD 100 Mode D'emploi

6.2 Changing the displayed units (MPa / psi)

Press MENU/ZERO for 2 seconds. MEnu will be displayed.
Continue press MENU/ZERO briely until the required measurement unit
is displayed.
Press RESET/OK to conirm selection.
Wait a few seconds and the display reverts to the actual pressure reading
display or press to continue to 6.3.

6.3 Displaying serial number

Follow steps given in 6.2 above and continue pressing MENU/ZERO briely
until the serial number is displayed.
Wait a few seconds and the display reverts to the actual pressure reading
display or press RESET/OK to return to actual values immediately.
12 SKF THGD 100