Charging The Battery; Inserting The Battery; Removing The Battery - Hilti NPU 100 IP-A22 Notice D'utilisation Originale

Poinçonneuse électrohydraulique sans fil
Masquer les pouces Voir aussi pour NPU 100 IP-A22:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Storage temperature
Battery charging starting temperature
5
Operation
5.1
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 5
5.3

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.4

Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.5
Assemble Hilti retaining leash (optional)
ATTENTION
Damage to the tool and/or the retaining leash. Incorrect handling may lead to damage to the tool and/or
retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use retaining leashes longer than 6 ft (2 m).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows a securing cord or leash to be attached.
National regulations applicable to working in high positions must be observed when working with the
tool.
1. Remove the battery.
2. Insert the two tabs on the retaining leash into the slots on each side of the base.
3. Secure the retaining leash with the screws supplied.
4. Refit the battery.
6
English
2
2321734
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
*2321734*

Publicité

Table des Matières
loading

Table des Matières