Dry Installation - Oase Neptun 1600 Notice D'emploi

- English -
Submerged installation
● Operation with the pre-filter fitted.
1. Push the pre-filter over the suction unit and
fasten the filter using the bayonet closure.
2. Place the unit in the water at the desired
position.
● Ensure that the unit is fully submerged.
Maximum installation depth:13.3 ft.

Dry installation

1. Bolt the suction unit on and turn the priming opening
to an optimum position for priming and connecting
the suction hose.
2. Connect the suction hose to the suction unit.
● Always position the unit below the water line to
prevent dry running and the intake of air when
switching on and operating the unit. Risk of
damage!
● Never connect the unit to a water line.
● Install the unit so that it is not exposed to direct sun
radiation (max. 104 ºF - 40 ºC).
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
• Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the
water.
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
!
Protective measure: Check the water level at regular intervals. Always place the unit below water level.
Important:
● The unit turns on automatically when power connection is established.
1. Turning on: Connect the unit to the outlet.
2. Switching off: Unplug the unit from the outlet.
● The amount of water flowing through is adjustable by the flow through regulator
Attention! The installed temperature sensor automatically turns the pump off, if it is overloaded. The
!
pump automatically switches on again once the motor has cooled down. Risk of accident!
4