Technical Information; Failure And Error Messages; Customer Service - uebe cyclotest baby Mode D'emploi

Technical information

Failure and error messages

Failure en-
countered
Display "L"
Display "H"
Display "E"

Customer service

The unit may only be repaired by the manufacturer or by an expressly
authorised organisation.
Please contact:
EN-75
Possible cause
- Sensor in the warm-up phase
- Temperature too low
- Possible technical fault
- Temperature too high
- Fever
- Illness
- Possible technical fault
- Measured value not stable
- Sensor removed before end of
measurement
UEBE Medical GmbH
Zum Ottersberg 9
97877 Wertheim, Germany
Phone: +49 (0) 9342/924040
Fax:
E-mail: info@uebe.com
Internet: www.uebe.com
Corrective action
- Continue measuring until
end of measurement
- Repeat measurement
- If "L" is permanently
displayed, contact cyclotest
service hotline
- If "H" is permanently
displayed without fever,
contact cyclotest service
hotline
- Repeat measurement
- If "E" is repeatlitly displayed,
contact cyclotest service
hotline.
+49 (0) 9342/924080