Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12) SCAN TYPE
Select
the TYPE of SCAN.
At [
] menu, rotate PUSH knob (6) to
"
"means scanning stops when busy channel is founded.
" " means scanning stops when busy channel is founded and return to scan
after 5 seconds.
13) BACKLIGHT COLOR
Select
the BACKLIGHT COLOR of the unit.
] menu, rotate PUSH knob (6) to
At [
Three colors are possible "
" (orange/default), "
14) BACKLIGHT BRIGHTNESS
Adjust
the BACKLIGHT BRIGHTNESS of the unit.
] menu, rotate PUSH knob (6) to
At [
Brightness level: 1 ~ 9, default: 9.
15) s/t KEYS SETTING
Select
the UP/DOWN KEY feature.
] menu, rotate PUSH knob (6) to
At [
"
" means s/t keys changes CHANNEL (default).
"
" means s/t keys changes FREQUENCY.
Note: If FREQUENCY is selected. Press PUSH knob (6) to select the frequency
digit to be increased by the s/t keys.
16) DW SETTING
Set
the CHANNEL use with DUAL WATCH function.
At [
] menu, press BAND key (21) to
key (18) to select desired modulation mode, rotate PUSH knob (6) to
channel. Default: band: I - modulation: FM - channel: 09.
See DUAL WATCH function, page 9.
17) CTCSS / DCS SETTING
Set
the operating mode of CTCSS/DCS.
In the menu [
], rotate the PUSH knob (6) to
mode of CTCSS and DCS.
In "
" mode, the value (of tone and code) is equivalent for transmission
and reception (default mode).
In "
" mode, the value (of tone and code) for transmission can be different
(unlike) from the one of reception.
See function CTCSS/DCS page 9.
select
the Type.
select
the Color.
" (green) or "
" (blue).
select
the BRIGHTNESS.
select
the Feature.
select
desired band, press MODE
select
select
the operating
18) RESET
Initialization
of the unit.
At [
] menu,
select
"
" for all functions and channels setting initialized.
Short press PUSH knob (6) to confirm. Wait until LCD shows "
D) TECHNICAL CHARACTERISTICS
1) GENERAL
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
12
"
" for all functions setting initialised,
: AM / FM / USB / LSB / CW
: from 28.000 MHz to 29.700 MHz
: 50 ohms
: 13.8 V
: 6.69 (W) x 9.84 (D) x 2.05 (H) inches
170 (W) x 250 (D) x 52 (H) cm
: 3.09 lbs / 1,4 kg
: microphone UP/DOWN with support,
mounting cradle, screws and fused
power cord.
: +/- 300 Hz
: 12 W AM / 28 W FM /
31 W USB-LSB (PEP) / 12 W CW
: inferior to - 50 dBc
: 300 Hz to 3 KHz in AM/FM/USB/LSB
: 3.0 mV
: 6 A (with modulation)
: 2 %
: 0.7 µV - 110 dBm (AM)
0.35 µV - 116 dBm (FM)
0.28 µV - 118 dBm (USB/LSB/CW)
: 300 Hz to 3 kHz in AM/FM/LSB/USB
: 60 dB
: 3 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 400 mA nominal / 600 mA maximum
select
".
Publicité
Table des Matières
