Rear Panel Connections; Digital Outputs - Cambridge Audio azur 740C Manuel D'utilisation

Rear panel connections

Manufactured in an
Power
ISO9002 approved facility
1
Designed in London, England
This device complies with
part 15 of FCC rules
On Off
azur 740C Upsampling
Compact Disc Player
Caution
Risk of electric shock. Power Rating: 230V AC ~ 50Hz
Do not open.
Max Power Consumption: 25W
Avis
Risque de choc electrique. Power AC
Ne pas ouvrir.
Achtung
Vorm öffnen des gerätes.
Netzstecker ziehen.
2
Power On/Off
1
Switches the unit on and off.
AC power socket
2
Once you have completed all connections to the amplifier, plug the AC
power cable into an appropriate mains socket then switch on. Your
compact disc player is now ready for use.
IR (Infra Red) Emitter In
3
Allows modulated IR commands from multi-room systems or IR repeater
systems to be received by the amplifier. Commands received here are
not looped out of the Control Bus. Refer to the 'Custom Installation'
section for more information.
Control Bus
4
In - Allows un-modulated commands from multi-rooms systems or other
components to be received by the unit.
Out - Loop out for control bus commands to another unit.

Digital outputs

5
The digital outputs allow a separate DAC or digital recording device to be
connected. The sophisticated DSP software in the 740C even allows
these outputs to be set to output raw (pass through) or upsampled data
independently from the main audio outputs. Refer to the 'CD player
setup' section for more information.
S/P DIF CO-a a xial Digital - To obtain best results, use a high quality 75
ohm digital RCA interconnect cable (not one designed for normal audio
use).
Toslink Optical Digital - Use a high quality TOSLINK fibre optic
interconnect cable designed specifically for audio use.
Only one of the two output types should be used at a time.
4 5
3
IR Emitter Control Bus Digital Outputs
S/P DIF Toslink
In In Out
Co-axial Optical
AЯ 46
6 7
Digital Inputs 1 Digital Inputs 2
S/P DIF Toslink S/P DIF Toslink
Co-axial Optical Co-axial Optical
& Digital Inputs 1 / 2
6 7
The digital inputs allow the digital outputs of other source components
to be connected to the 740C. The 740C can then act as a very high
quality upsampling DAC, improving the sound quality of the connected
sources. Two digital inputs allow two external sources to be connected:
S/P DIF CO-a a xial Digital - Use a high quality 75 ohm digital RCA
interconnect cable (not one designed for normal audio use).
Toslink Optical Digital - Use a high quality TOSLINK fibre optic
interconnect cable designed specifically for audio use.
Only one of the two input types for each input should be used at a time.
Line Output
8
Use good quality RCA/Phono interconnect cables from these sockets to
any line level input on your amplifier.
azur 740C
Incorporating Q5 ™
from:
ANAGRAM
TECHNOLOGIES
8
Class 1 Laser Product
Left Luokan 1 Laserplaite
Klass 1 Laserapparat
Right
Line Output
www.cambridge-audio.com
5