Notes/Warnings - easydriver active 2.8 Instructions D'assemblage Et Mode D'emploi

7. Commissioning/operation
B6 Swivelling off the drive rollers:
Secure the vehicle against rolling off
before swivelling off the drive rollers!
The subsequent wok must be performed in front of and
behind the axle!
Secure the vehicle against rolling off once the manoeu-
vring process has been completed. Swivel off the rive
rollers. Attach a suitable wrench or adapter (19 mm) to
the hexagonal part for this purpose and turn the spindle
away from the wheel until the arrow indicator is at the
far end of the green range, see Figure 3.1 (<= OFF).
Repeat this process for the second axle.
B7 Switching OFF the easydriver
Switch off your easydriver by pressing the
I/O button on your remote control unit once.
The drive units may not remain engaged on the tyres,
as this might damage the tyres. Driving with a towing
vehicle while the drive units are connected is prohibit-
ed, as it might damage the caravan or trailer as well as
the towing vehicle.
B8 Switching OFF the system
Switch OFF the main or remote
switch, depending on the model.
The easydriver must be switched off after
every operation by using these switches. .
Pull the handbrake and/or secure your caravan or
trainer with trestles against unintended rolling-off.
GB10

8. Notes/warnings

8. Notes/warnings
The easydriver uses bidirectional communication be-
tween the remote control and the base station. This
makes it possible to transfer information from the base
station to the remote control.
Operating status display LED, blue

1x flashing per second: searching for the
base station

Permanently lit up: Connected to the base
station, system ready for operation.
Remote control battery LED, red

Symbol not lit up: Battery voltage is in order

1x per second flashing: Batteries should be
exchanged

Permanently lit up: Batteries empty. All
driving functions are terminated.