easydriver active 2.8 Instructions D'assemblage Et Mode D'emploi page 29

7. Commissioning/operation
B5 Direction buttons:
You can press any of the movement buttons singly or
together. The arrows on the buttons show the respec-
tive direction of movement.
Driving forwards
All drive units pull forwards with full
power.
Turn towards the right front*
Only the left drive units pull forwards
with full power. Only the right drive
units are blocked.
Turn towards the left front*
Only the left drive units pull forwards
with full power. Only the left drive units
are blocked.
Turn towards the right rear*
Only the left drive units pull backwards
with full power. Only the right drive
units are blocked.
Turn towards the left rear*
Only the right drive units pull back-
wards with full power. Only the left
drive units are blocked.
* The inner wheels are blocked during this rotational
movement. This may cause the wheels to dig into soft
ground. Use this movement only when the ground is
sufficiently firm.
Driving backwards
All drive units pull backwards with full
power.
Arc towards the front right
The left drive units pull forwards with
full power. The right drive units pull
forwards with reduced power.
Arc towards the front left
The right drive units pull forwards with
full power. The left drive units pull
forwards with reduced power.
Arc towards the rear right
The left drive units pull backwards with
full power. The right drive units pull
backwards with reduced power.
Arc towards the rear left
The right drive units pull backwards
with full power. The left drive units pull
backwards with reduced power.
"TANGO"-type right turn
The easydriver automatically manoeu-
vres along a curve (see Figure). The
electronic system automatically switch-
es the direction of rotation.
"TANGO"-type left turn
The easydriver automatically manoeu-
vres along a curve (see Figure). The
electronic system automatically switch-
es the direction of rotation.
"TANGO"-type right turn
Buttons for automated swivelling on
and swivelling off. These have no
function in the easydriver ACTIVE
version.
The cable connections of the right or left drive units to
the base stations and the motors must be checked and
reversed as required (see connection plan Fig. 9) when
the manoeuvring movements do not correspond to the
symbols shown on the remote control.
It is essential to switch OFF the main switch and to
separate the base stations from the voltage supply
before performing any work.
"TANGO"-type left turn
GB9