Troubleshooting - Toolson WS7200PRO Traduction Des Instructions D'origine

Troubleshooting

Fault
1. Saw blade comes •
loose after the
engine is turned
off.
2. Engine does not •
start •
•
•
3. Motor wrong rota- •
tion direction •
4. Motor does not •
provide power, the
fuse is activated •
5. Burning surfaces •
on the cutting •
surface
6. Saw does not •
slow down after
switching off
7. Engine runs •
irregularly •
8. Engine overheats •
m Electrotechnical maintenance works should only be carried out by an electronics technician!
On removal of the machine the local legal regulations have to be abided by.
Please contact the manufacturer in case of disposal.
The follolwing details are required to allow correct and fast processing of a spare parts order:
1. Machine type
2. Machine number
3. Description, order number for spare part.
4. When ordering spare parts for electric equipment, the date shown on the nameplate of motor and switch must be
quoted.
5. The color (RAL number) of the desired spare part.
6. Quantity of the required spare part.
7. Exact details of address and type of dispatch.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
Mounting nut has not been suffi-
ciently tightened.
Failure power protection
Extension cable defective
Connections to motor or switch not
working
Motor or switch defective
Defective capacitor
Wrong connection
Cross-section of the extension line
is not sufficient
Overload by blunt saw blade
Blunt saw blade
Wrong saw blade
Mechanical brake defective
Switch defective
Extension cable defective
Airflow to the engine restricted.
Remedy
• Tighten the mounting nut; right-hand thread.
• Check the mains fuse
• Replace the extension cable
• Have it checked by qualified electricians
• Have it checked by qualified electricians
• Have it checked by qualified electricians
• Change the polarity of the wall socket
• See „Electrical connection"
• Change saw blade
• Sharpen the saw blade, replace
• Replace saw blade
• Replace brake
• Contact the service
• Do not cover the engine with elements.
GB 19