Toolson WS7200PRO Traduction Des Instructions D'origine page 14

• The machine must only be used in technically per-
fect condition in accordance with its designated
use and the instructions set out in the operating
manual, and only by safety-conscious persons who
are fully aware of the risks involved in operating
the machine. Any functional disorders, especially
those affecting the safety of the machine, should
therefore be rectified immediately.
• The manufacturer's safety instructions, operating
instructions and maintenance instructions as well
as the dimensions given in the technical data must
be observed.
• The applicable accident prevention regulations and
other generally accepted safety regulations must
be complied with.
• The Scheppach machine may only be used, main-
tained, and operated by persons familiar with it and
instructed in its operation and procedures. Arbi-
trary alterations to the machine release the man-
ufacturer from all responsibility for any resulting
damages.
• The Scheppach machine may only be used with
original accessories and original tools made by the
manufacturer.
• Any other use exceeds authorization. The manufac-
turer is not responsible for any damages resulting
from unauthorized use; risk is the sole responsibil-
ity of the operator.
• Use the required sawblade in accordance with the
EN 847-1 norm depending on the type of cut and
type of wood (solid wood, plywood or chipboard).
• Ensure adequate lighting.
Attention: risk of accident!
The wood must always be seated on both sides of the saw blade on the v-block of the rocker. (see arrows)
Caution Danger of accidents!
Wear safety shoes.
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
14 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Make sure that the machine is secure on the ground
when installing the machine.
• There should be no obstacles to the machine.
• The machine may only be operated outdoors with-
out exhaust.
Remaining hazards m
The machine has been built using modern tech-
nology in accordance with recognized safety
rules. Some remaining hazards, however, may
still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Danger to health from wood dusts or wood chips.
• Always wear personal protective equipment such
as eye protection and dust mask.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear
personal protective gear such as ear protection.
• Hazardous current, when using improper electrical
connections.
• Even when all safety measures are taken, some
remaining hazards which are not yet evident may
still be present.
• Remaining hazards can be minimized by following
the instructions in "Safety Precautions", "Proper
Use" and in the entire operating manual.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Scheppach special accessories are used.
Caution Danger of accidents!
To wear ear protection.
Wear safety glasses.
Before any maintenance, cleaning or
repair work, disconnect the unit from the
power supply!