Training Of The Operator; Technical Data; Scope Of Delivery; Assembly - Toolson WS7200PRO Traduction Des Instructions D'origine

Training of the operator

• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Do not wear tight clothing. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.
Construction measurements
Total length
Total width
Total height
Rocker support
Saw blade ø
Idle speed motor
Cutting speed saw blade
Weight
Power unit
Motor
Input power P1
Output power P2
Operating mode
Rated current
Work information
Cutting height Spar
Turning cut
Piece of wood
Specific noise values
The according to the EN 23746 for the sound pres-
sure level resp. EN 31202 (correction factor k3 after
supplement A.2 from EN 31204 calculated) for the
sound pressure level on the working site ascertained
noise emission value amounts under the foundations
of ISO 7904 supplement a performed working con-
ditions to
Sound pressure level in dB
Idle LwA / Processing LwA
Sound pressure level on wor-
king site in dB
Idle LqAeq / Processing LqAeq
The specified values are emission values and there-
fore should not at the same time be reliable working
site values. Although there is a correlation between
emission and immision levels, it cannot unfailingly be
derived if extra precautions need to be taken or not.
Factors, which influence the actual availabe immusion
value on working site, include the peculiarities of work-
ing area, other sources of noise, e.g. the number of
machines and other adjoining processes. The allowed
working values could vary from country to country.
However, the information should qualify the user, to be
able to make an estimation of the dangers and risks.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Technical Data

mm
mm
mm
mm
mm
1/min
m/sec
kg
V/Hz
kW
kW
A
max. mm
min. mm
max. mm
max. mm
Reserve technical changes!

Scope of delivery

• Rocker circular saw
• Allen key or open-end wrench
• Locking pin
• Operating instructions

Assembly

The machine is supplied completely assembled them,
and is therefore ready to use.
95 / 102

Setting-up and adjustment

• Please pay attention that your rocker circular saw is
set up stable and on a leveled floor.
85 / 92
• The workplace must be well lit.
• There should be no obstacles to the machine.
1270
730
1130
670
700
1400
52
92
380 - 420 / 50
5,2
3,58
S6 / 40%
10
240
60
250
380x240
GB 15