Cleaning The Guide Bar Lubricating The Sprocket Nose - Dolmar ES-151 Manuel D'emploi Et De Sécurité

30°
E
- The file holder makes file guidance easier. It is marked for
the correct 30° sharpening angle (keep the marks parallel
with the chain when filing, see illustration) and limits the cut
depth to the correct 4/5 of the file diameter. See "Accesso-
ries" for the order number.
Cleaning the guide bar
lubricating the sprocket nose
CAUTION:
Protective gloves must be worn.
H
4/5
F
- After having sharpened the chain, the height of the depth
limiter must be checked by means of a chain gauge. See
"Accessories" for the order number.
- Correct even the smallest excess height with a special flat
file (F). See "Accessories" for the order number.
- Round off the front of the depth limiter (G).
Regularly inspect the bearing surfaces of the guide bar for
damage, and clean them with a suitable tool.
If the saw is used intensively it will be necessary to lubricate the
return sprocket bearings regularly (once a week). To do this,
first thoroughly clean the 2 mm hole at the tip of the guide bar,
and then press in a small amount of multi-purpose grease.
Multi-purpose grease and grease guns are available as acces-
sories.
Multi-purpose grease
Grease gun
G
(order no. 944 360 000)
(order no. 944 350 000)
15