Editing A Freeze Picture; Preparation - Sony RM-450A Mode D'emploi

Editing a Freeze Picture

Connections
RM-450A
REF. VIDEO IN RECORDER

Preparation

Operation
When the BKU-903A digital time base corrector (optional) and BKU-904
digital noise reducer (optional) are installed in the connected BVU-900/
900P or BVU-950/950P, you can edit a freeze picture by using the signal
output from the CUE OUT connector.
Connect the CUE OUT connector of this unit and the REMOTE-2 (24 pin)
of the BVU-900/900P or BVU-950/950P.
Refer to the maintenance manual of the BVU-900/900P or BVU-950/
950P.
AC IN
PLAYER CUE OUT
CUE OUT
CUE OUT → L-FREEZE IN (Pin No.16)
GND → GND (Pin No.24)
Set the SYSTEM PRESET switch on the left side as follows:
Left Side
1
Set the FREEZE button of the BVR-55/55P remote control unit
supplied with the BKU-903A to ON.
2
Perform a preview or automatic edit.
The BVU-900/900P or BVU-950/950P outputs a freeze picture from
the time set by the SYSTEM PRESET switch to the OUT point.
BVU-950/950P
7 6 5 4 3 2
Set the CUE OUT start position:
000 (0 sec.) to 111 (7 or 10 sec.)
Set to ON.
REMOTE-2
1 0 ON
OFF
29