Executing The Edit - Sony RM-450A Mode D'emploi

Executing the Edit

RESET
HOURS MINUTES SECONDS FRAMES
POWER PLAYER
ON
STDBY EJECT
OFF
PLAY STILL REW FF
REVERSE FORWARD
SHUTTLE JOG
SERVO IN OUT IN OUT SERVO
EDITING CONTROL UNIT RM-450A HOURS MINUTES SECONDS FRAMES
ASMBL V A1 A2
EDIT MODE
– +
AUDIO SPLIT TRIM LAST EDIT
REVERSE
IN OUT GO TO IN OUT
PLAYER RECORDER
ENTRY
AUTO EDIT RVW
PREVIEW ALL STOP
/END /JUMP
Press the AUTO EDIT/END button after the edit points are entered.
The AUTO EDIT/END button lamp lights and editing is started.
You can observe the edit on the monitor connected to the recorder. The
tape runs from the time (as set by using the PREROLL selector) prior to
the IN point to 2 seconds after the OUT point.
VTR operation at the OUT point
When the editing has finished, a still picture of the OUT point is displayed.
Assemble edit mode: Editing is continued for 2 seconds after the OUT
point, and then the recorder returns to the OUT point.
Insert edit mode: Editing is finished at the OUT point, and both the
recorder and player run to the tape point 2 seconds after the respective
OUT points. Then, the recorder returns to the OUT point and the still
image of the OUT point is output.
Stopping the edit
Press the AUTO EDIT/END button to stop editing.
The point where you pressed the button is regarded as the OUT point of
this editing, and editing is completed in the same manner as that already
described.
Inside panel
RESET TOTAL PLAYER
TC
RTC
RECORDER CTL
LEARN
REC EDIT STDBY EJECT
PLAY STILL REW FF
FORWARD
SHUTTLE JOG
AUTO EDIT/END button
PREROLL selector
PREROLL SYNCHRO RECORDER
7 ON/CF TC
5 ON RTC
3 OFF CTL
SYSTEM PRESET
7 6 5 4 3 2 1 0 ON 7 6 5 4 3 2 1 0
OFF
21