Split Editing - Sony RM-450A Mode D'emploi

Useful Editing

Split Editing

26
In the insert edit mode, you can start editing the video, audio channel-1
and channel-2 independently. This is called "split editing".
RESET
HOURS MINUTES SECONDS FRAMES
PLAYER
POWER
ON
STDBY EJECT
3
OFF
PLAY STILL REW FF
REVERSE FORWARD
2
SHUTTLE
1
Selecting the insert channel
Press the desired insert button(s) to select the signal(s) to insert: V, A1
and A2.
2
Entering the edit points of the video channel
Enter the video IN/OUT points when you are to insert the video
channel of the player and the recorder.
3
Entering the IN point of the audio channel
Press the AUDIO SPLIT button and enter the audio IN point of the
player or the recorder.
The AUDIO SPLIT button lamp blinks.
4
Executing the automatic edit
Press the AUTO EDIT/END button.
Editing begins and automatically finishes.
What does the AUDIO SPLIT lamp indicate?
You can enter only the audio edit points while the AUDIO SPLIT lamp is
lit. If you press the AUDIO SPLIT button again while its lamp is lit, the
lamp starts blinking and you can enter the video edit points.
You can enter the audio IN/OUT points first
Press the AUDIO SPLIT button and enter the audio IN/OUT points of the
player and the recorder in Step 2. Then press the AUDIO SPLIT button
again and enter the video IN point of the player or the recorder in Step 3.
SERVO IN OUT IN OUT SERVO
EDITING CONTROL UNIT RM-450A HOURS MINUTES SECONDS FRAMES
ASMBL V A1 A2
EDIT MODE
– +
AUDIO SPLIT TRIM LAST EDIT
IN OUT GO TO IN OUT
PLAYER RECORDER
ENTRY
JOG
AUTO EDIT RVW
PREVIEW ALL STOP
/END /JUMP
RESET TOTAL
1
RECORDER
REC EDIT STDBY EJECT
PLAY STILL REW FF
REVERSE FORWARD
SHUTTLE JOG
4