Using Your Electronic Smartdoor - Petsafe Electronic SmartDoor Guide D'emploi

Step 4: Attach the SmartKey ™ Transmitter to the Pet's Collar
Thread your pet's collar through the SmartKey's attachment
loop. Your pet's collar must be ¾" wide or less. The
SmartKey transmitter should hang under the pet's neck.
If your pet's collar is too large to thread through the key, a
key ring has been provided for use for attachment to your
pet's collar ring.
__________________________________________________________________________________________

Using Your Electronic SmartDoor

™
Entering Locked Mode
The Electronic SmartDoor ships from the factory in the Locked mode. The Electronic SmartDoor will
enter Locked mode when the 4 D-cell batteries are placed in the Battery Box.
To enter Locked mode when the Electronic SmartDoor is in either the Unlocked or Automatic mode,
depress and hold the Mode/Reset button until the red LED is illuminated. While the red LED is
illuminated, release the Mode/Reset button. The fl ap is locked.
Entering Unlocked Mode
To enter Unlocked mode, depress and hold the Mode/Reset button; the red LED will illuminate
indicating Locked mode, then the green LED will illuminate. While the green LED is illuminated,
release the Mode/Reset button. The fl ap will unlock.
Entering Automatic Mode
To enter Automatic mode, depress and hold the Mode/Reset button; the green LED will illuminate
indicating Unlocked mode, then the yellow LED will illuminate. While the yellow LED is illuminated,
release the Mode/Reset button. The fl ap will enter Automatic mode. The fl ap will move down (locking)
and the Electronic SmartDoor will seek the presence of the SmartKey transmitter. When the unit
senses the SmartKey transmitter, the fl ap will unlock. When the SmartKey signal is no longer detected,
the fl ap will lock. The SmartKey signal must be out of range of the Electronic SmartDoor for 10
seconds before the door will respond to the SmartKey signal again.
Learning a SmartKey Transmitter Code
To enter Learn mode, depress and hold the Learn button until the green LED begins to fl ash. Release
the button. Bring the SmartKey into range of the Electronic SmartDoor; the green LED will stop
blinking and will illuminate continuously. The code has been successfully added to memory.
Learn Mode may be accessed when the Electronic SmartDoor is in any operating mode. Up to fi ve
different SmartKey codes can be added to memory. When the Learn mode is activated, if no SmartKey
transmitter signal is detected, the green LED will blink for 60 seconds and extinguish; the Electronic
SmartDoor will return to its previous mode.
Error Mode
When the yellow LED is fl ashing, the Collar ID is in Error mode, indicating an error has occurred.
Should the fl ap be off-of-center, either to the inside or outside, while the fl ap is being pushed down to
lock, the Electronic SmartDoor will stop moving the fl ap down and start fl ashing the yellow LED. The
Electronic SmartDoor will remain in Error mode until the error is cleared. Simply center the fl ap, then
depress and hold the Mode/Reset button until the Electronic SmartDoor begins to lock.
Low Battery Condition
When the red LED is fl ashing, the Electronic SmartDoor is in low battery condition. The four D-cell
batteries should be replaced as soon as possible to ensure the Electronic SmartDoor continues to operate
properly.
6 1-800-732-2677 (US), 1-800-457-3911 (Canada)