Maintenance; General; Checking, Maintaining And Servicing Chain Saw Safety Equipment; Battery Connectors - Husqvarna 136 Li Manuel D'utilisation

General

The user must only carry out the maintenance and
service work described in this manual. More extensive
work must be carried out by an authorized service
workshop.
Checking, maintaining and
servicing chain saw safety
equipment
WARNING! Always remove the battery
!
before any assembly, maintenance and/
or checking is done on the machine.
Note! All servicing and repair work on the machine
requires special training. This is especially true of the
machine's safety equipment. If your machine fails any of
the checks described below we recommend you to
contact our servicing dealer.
Important! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
Chain brake and front hand guard
Checking the front hand guard
• Make sure the front hand guard is not damaged and
that there are no visible defects such as cracks.
(Figure 98)
• Move the front hand guard forwards and back to make
sure it moves freely and that it is securely anchored to
the machine. (Figure 99)
Checking the inertia brake release
• Place the chain saw, deactivated, above a stump or
other stable surface. Release the front handle and let
the chain saw fall by its own weight, rotating around
the rear handle towards the stump. (Figure 100)
When the bar hits the stump the brake should be
activated.
Checking the brake trigger
• Activate the chain saw. Make sure the saw chain does
not touch the ground or any other object. See
instructions under the heading Starting and stopping.
• Grasp the chain saw firmly, wrapping your fingers and
thumbs around the handles. (Figure 65)
• Apply full power and activate the chain brake by tilting
your left wrist forward onto the front hand guard. Do
not let go of the front handle. The chain should stop
immediately. (Figure 101)
1156931-49 Rev.1 2015-04-30

MAINTENANCE

Power trigger lockout
• Make sure that the power trigger is locked at the idle
setting when the power trigger lockout is released.
(Figure 102)
• Press the power trigger lockout and make sure it
returns to its original position when released.
(Figure 103)
• Check that the power trigger and power trigger lockout
move freely and that the return springs work properly.
(Figure 104)
• Activate the chain saw and apply full power. Release
the power trigger and check that the saw chain stops
and remains stationary.
Chain catcher
• Check that the chain catcher is not damaged and is
firmly attached to the body of the chain saw. (Figure
105)
Keypad
• Activate the chain saw (green LED on) and make sure
the chain saw deactivates when the start/stop button
is pressed (green LED off). (Figure 106)

Battery connectors

Clean the battery and the machines battery compartment
with a soft brush after use. Make sure all cooling slots and
battery connectors are cleaned. (Figure 107)

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake (left side of the machine).
2 A fan on the motor.
• Clean the cooling system with a brush once a week,
more often in demanding conditions. A dirty or
blocked cooling system results in overheating which
causes damage to the machine. (Figure 108)

Battery

• Make sure the battery is not damaged or deformed
and that there are no visible defects such as cracks.
(Figure 109)

Battery charger

• Make sure the battery charger and the power supply
cord is not damaged or deformed and that there are
no visable defects such as cracks. (Figure 110)
–
English 29