Remote Control - Yamaha AX-497 Mode D'emploi

The sound is
The power of this unit is turned off, or this
degraded when
unit is set to the standby mode.
listening with the
headphones
connected to the CD
player or the tape
deck connected to
this unit.
The sound level is
The LOUDNESS control is functioning.
low.
The input source
The CD/DVD DIRECT AMP switch is
cannot be changed
turned on.
although the INPUT
The TAPE MONITOR function is turned
selector is rotated.
on.
Using the BASS,
The CD/DVD DIRECT AMP switch (or
TREBLE, BALANCE
the PURE DIRECT switch for AX-497
and LOUDNESS
only) is turned on.
controls does not
affect the tonal
quality.

■ Remote control

Problem
The remote control
Wrong distance or angle.
does not work nor
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Turn on the power of this unit.
Set the LOUDNESS control to the FLAT position.
Turn off the CD/DVD DIRECT AMP switch.
Turn off the TAPE MONITOR function.
The CD/DVD DIRECT AMP switch (or the PURE
DIRECT switch for AX-497 only) must be turned off
to use those controls.
Cause
The remote control will function within a maximum
range of 6 m and no more than 30 degrees off-axis
from the front panel.
Reposition this unit.
Replace all batteries.
TROUBLESHOOTING
Remedy
11
13
13
4
13
Refer to
page
6
—
6
17