Fig. 41; Loose Parts List - Ryobi EMS-2026SCL Manuel D'utilisation

GB
F D
OTHER SAFETY PRECAUTIONS FOR USING
SLIDING COMPOUND MITRE SAW
For service personnel.
CAUTION: Avoid exposure to beam when servicing.
Complies with EN60825-1:1994+ A2:2001+ A1:2002 as
a Class 2 Laser.
WARNING
Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the
beam, please observe all safety rules as follows.
The laser shall be used and maintained in
■
accordance with the manufacturer's instructions.
Never aim the beam at any person or an object other
■
than the workpiece.
The laser beam shall not be deliberately aimed at
■
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25 s.
Always ensure the laser beam is aimed at a sturdy
■
workpiece without reflective surfaces, i.e. wood or
rough coated surfaces are acceptable. Bright shiny
reflective sheet steel or the like is not suitable for
laser use as the reflective surface could direct the
beam back at the operator.
Do not change the laser light assembly with a
■
different type. Repairs must be carried out by
authorised Ryobi service centre.
FEATURES
1. Laser on/off switch
2. Laser
3. Trigger
4. Lower blade guard
5. Live indicator
6. Throat plate
7. Bevel scale
8. Material support arm
9. Mitre lock knob
10. Mitre scale
11. Mitre table
12. Vice or workpiece clamp
13. Rear fence
14. Lock down pin
15. Spindle lock button
16. Bevel lock button
17. Dust bag
18. Upper blade guard
19. Laser adjustment screw
E I P NL S DK N FIN
English
20. Lower guard release lever
21. Sliding lock
22. Sliding gear assembly
23. Rear lock knob
24. Sliding fence
25. Handle
26. Carrying handle
27. Depth of cut adjustment screw
Fig. 37: CROWN MOLDING FLAT ON MITRE TABLE
28. CEILING
29. WALL
30. TOP EDGE AGAINST FENCE =
LEFT SIDE, INSIDE CORNER
RIGHT SIDE, OUTSIDE CORNER
31. INSIDE CORNER
32. OUTSIDE CORNER
33. BOTTOM EDGE AGAINST FENCE =
RIGHT SIDE, INSIDE CORNER
LEFT SIDE, OUTSIDE CORNER
TOOLS NEEDED (NOT INCLUDED)

Fig. 41

A. 5 mm hex key
B. 12 mm combination wrench
C. Framing square
D. Combination square

LOOSE PARTS LIST

Fig. 42
E. Dust bag
F. Vice or workpiece clamp
G. Material support arm
H. Clamp bracket screws
I. Clamp bracket
J. Hex Wrench
SPECIFICATIONS
Power Input
No Load Speed
Blade Diameter
(Ø 254 mm x Ø 30 mm x 40 T)
Blade Arbor
Weight
15
GR H CZ RUS
2000 watt
4500 min-
254 mm
30 mm
18 kg
RO PL
1