PRESIDENT MC KINLEY USA 12/24 V Manuel D'utilisation page 11

Press PTT switch (13), 9/19 / DW key (10) , or long press SCAN
key (9) again to exit SCAN function.
WEATHER MODE
Press and hold the SCAN key (9) for 1 second to activate
the SCAN function (for WEATHER channels) in an increasing
way. "SCAN" is displayed. The scanning stops as soon as
there is a busy channel. The scanning starts again in an
increasing way by turning to the right the CH rotary knob
or pressing the UP key (6) on the microphone, or in a de-
creasing way, by turning to the left the CH rotary knob or
pressing the UP key (6) on the microphone.
Note: If the ALERT function is activated, the SIREN tone
sounds (see § ALERT below) when a tone is detected in the
selected WEATHER channel only. Use first SCAN function in
WEATHER mode to detect tones in all the WEATHER channels.
A new long press on SCAN disables the SCAN function.
M2
See § MEMORY page 12.
10) 9/19 ~ DW ~ M3
9/19
(short press)
Channels 9 and 19 are automatically selected by pressing
this key. A push activates channel 9, "EMG" is displayed. A
new push activates channel 19, "EMG" is displayed. A new
push returns to the previous channel, "EMG"disappears.
DW
(long press)
Press and hold the DW key (10) for 1 second to activate the
DUAL WATCH function. "DW" is displayed. This function lets
you watch over channel 9 or 19 and the current channel. The
first long press activates the DW function between channel
9 and the busy channel. A new long press activates the
function between channel 19 and the busy channel. The
number of the selected channel, the memorized channel
included and channel 9 or 19 are alternately displayed.
"EMG" is also displayed at the same time as channel 9 or
19. The selected channel can be modified during the dual
watch. A new long press on DW key (10) disables the DW
function. "DW" disappears.
M3
See § MEMORY page 12.
11) •F/MEM ~ LOCK ~ •RF GAIN
•F/MEM
(short press)
Short press this key to enter in mode
when the function is on.
10 seconds without pressing any key.
For memories, see § MEMORY page 12.
LOCK
(long press)
Allows to lock all the keys on the front panel. If the KEY BEEP
function is on, an error beep sounds when a key is pressed.
A long press on LOCK key (11) activates/deactivates the
LOCK function. appears on the display when the func-
tion is activated. Transmission (microphone or vox) and
reception remain active.
•RF GAIN
(•F/MEM + •MIC/RF GAIN + CH rotary)
- Short press •F/MEM key (11)
Short press •MIC/RF GAIN key (11)
-
(or press 2 times the key 11).
- Turn the CH rotary knob (6) to adjust the gain with bargraph.
Long press the CH knob to validate the setting.
-
RF Gain bargraph always will be displayed in
11
2 FUNCTION. blinks
nd
automatically disappears after
RX mode.