PRESIDENT MC KINLEY USA 12/24 V Manuel D'utilisation page 10

Long press •VOX key (7) key in order to valid adjustments
and quit the Vox Adjustment mode.
When VOX SETTING is done the VOX function is automati-
cally ON. "VOX" appears on the display.
8) WEATHER ~ ALERT ~ M1
WEATHER
(short press)
CB functions are not allowed in
presses a not allowed key and KEY BEEP function is acti-
vated, the radio sounds error tone.
Press WEATHER key (8) in order to activate the
mode. "WEATHER" appears on the display. A new short
press on WEATHER key (8) disables the
"WEATHER" disappears.
The WEATHER mode allows to hear weather information.
When the mode is activated, use channel selector switches
to move through the 7 weather channels to find the active
channel in your local area.
ALERT
(long press)
The SIREN tone only sounds in
WEATHER
sound in mode.
Press and hold ALERT key (8) for 1 second to activate/
deactivate the ALERT function. When the function is on
and a tone is detected at the selected weather channel,
then the unit sounds SIREN tone. "ALERT" and the "Weather
channel" blink on the display. The unit cancel
mode and go to WEATHER
During a SIREN tone sound, press any key to stop the sound,
"ALERT" and the "Weather channel" stop blinking on the
display.
Note: The SIREN tone sounds when ALERT is detected in the
selected WEATHER channel only. Use first SCAN function in
WEATHER mode to detect tones in all the WEATHER channels
(see § WEATHER MODE above).
WEATHER
mode. If user
WEATHER
WEATHER mode.
CB PA
and mode. It does not
CB or
mode.
M1
See § MEMORY page 12.
9) NB/ANL/HIC ~ SCAN ~ M2
NB/ANL/HIC
(short press)
NB ANL: Noise Blanker / Automatic Noise Limiter. These filters
allow reducing back ground noises and some reception
interferences.
HI-CUT: cuts out the high frequency interferences.
Short press NB/ANL/HIC (9) key to alternate the different
status :
Filter icon appears on the display when status in on.
SCAN
(long press)
CB MODE
Press and hold SCAN key (9) for 1 second to activate SCAN
function (for CB channels) in an increasing way. "SCAN"
is displayed. The scanning stops as soon as there is a busy
channel. The scanning automatically starts 3 seconds
after the end of the transmission and no key is activated
PA
during 3 s. The scanning starts again in an increasing way
by turning to the right the CH rotary knob or pressing the
UP key (6) on the microphone, or in a decreasing way, by
turning to the left the CH rotary knob or pressing the DN
key (6) on the microphone.
While scanning, press •F/MEM key (11) to alternate between
All Channel Scan
In Memory Scan Channel
and the memorised channels are scanned.
10
Memory Channel Scan.
and
mode, channel 9, channel 19