Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and
makes the setting of the equipment into the dashboard
easier.
See cabling diagram page 67.
13) PTT ~ RF POWER ~ MIC GAIN ~ TALKBACK
PTT (Push To Talk)
Transmission key, press to transmit a message,
played and release to listen to an incoming communication.
RF POWER
(PTT + •F/MEM + CH rotary)
While pressing PTT switch (13)
-
Short press •F/MEM key (11)
Turn the CH rotary knob (6) to adjust the RF POWER with
-
bargraph.
Long press CH knob (6) to validate the setting
-
RF POWER bargraph will always be displayed in
MIC GAIN
(PTT + •F/MEM + • MIC/RF GAIN + CH rotary)
While pressing PTT switch (13)
-
Short press •F/MEM key (11)
-
Short press •MIC/RF GAIN key (11)
(or press 2 times the key 11).
Turn the CH rotary knob (6) to adjust the MIC GAIN with
-
bargraph.
-
Long press CH knob (6) to validate the setting
MIC GAIN bargraph will always be displayed in
TALKBACK
(PTT + •F/MEM)
The TALKBACK function allows to ear your own modulation
with the CB speaker.
While pressing PTT switch (13),
Long press •F/MEM key (11) to activate/deactivate TALK-
-
BACK function. When the function is on, "TALKBACK" is
displayed.
TALKBACK LEVEL
When the function is on, while pressing PTT switch (13),
Turn the CH rotary knob (6) to adjust the TALKBACK level.
-
9 steps from 01 to 09.
MEMORY
is dis-
This CB radio allows to memorize 3 channels with following
parameters: NB/ANL (on/off), HI-CUT (on/off), AM / USB / LSB.
To recall a memory:
-
Short press •F/MEM key (11). If the KEY BEEP function is
activated a beep sounds.
Short press M1 (8), M2 (9) or M3 (10) key to recall the mem-
-
ory."MEM" appears on the display and the number of the
selected memory (M1, M2 or M3) blinks.
TX
mode.
To memorize:
-
Select the channel and parameters to be memorized.
Short press •F/MEM key (11). If the KEY BEEP function is
-
activated a beep sounds.
-
Press M1 (8), M2 (9) or M3 (10) key during 1 second to store
the selected channel into memory. "MEM" appears on the
display and the number of the selected memory (M1, M2
or M3) blinks.
-
If the KEY BEEP function is activated a long beep confirms
the saving.
TX
mode.
To delete a memory:
-
Switch off the transceiver.
Keep the memory key M1 (8), M2 (9) or M3 (10) pressed
-
and switch on the transceiver.
-
The selected memory is deleted. "MEM" and the selected
memory number disappears.
12
(PTT + CH rotary)
(short press)
blinks.
(long press)
blinks.
Publicité
Table des Matières
