Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7) MODE ~ PA ~ •VOX
MODE
(short press)
This switch allows selecting the modulation mode AM, LSB
or USB; Your modulation mode has to correspond to the
one of your correspondent.
Amplitude Modulation / AM: communication on a field with
relief and obstacles at middle distance (the most used).
Upper and Lower Side Band / USB-LSB: used for long dis-
tance communications (according to the propagation
conditions).
Press MODE key (7) to alternate between :
PA (PUBLIC ADDRESS)
Long press PA key (7) to alternate between
mode.
PA
MODE. "PA" is displayed. An external loud speaker can
be connected to the unit by the PA jack plug located on
the back panel PA.SP. (D).
The CB messages received or transmitted into the micro-
phone will be directed towards the
amplified.
When PTT switch (13) is pressed, "on" is displayed, message is
{PA LEVEL}, Meter numbers indicate signal level.
To adjust PA level, press and keep PTT switch (13), turn the
CH rotary knob (6) and use the meter numbers indicators.
Message {PA LEVEL} blinks.
ROGER, SCAN, MEM, VOX are not allowed in
user set on
PA
mode while SCAN function, instant channel
9/19 mode or
WEATHER
(long press)
CB
PA
speaker and be
PA
mode. If the
mode, these are canceled.
•VOX
(•F/MEM + short press)
The VOX function allows transmitting by speaking into the
original microphone (or in the optional vox microphone)
without pressing the PTT switch (13). The use of an optional
vox microphone connected to the rear panel of the trans-
ceiver (E) disables the original microphone.
Press one time •F/MEM key (11) and short press •VOX key
(7) in order to activate the VOX function. "VOX" appears
on the display. Repeat the key combination to disable the
function. "VOX" disappears.
•VOX SET
(•F/MEM + long press)
Press one time the •F/MEM key (11) and press during 1 second
•VOX key (7) in order to activate the function VOX SETTING.
"VOX" blinks. Three adjustments are possible: Sensitivity /
Anti-vox level
and
PA
in order to go to the following adjustment (looping , , ).
The message shows the type of adjustment followed by its
level {SET-L1}, {SET-A1}, {SET-T1}.
-
Sensitivity : allows the adjustment of the microphone
(original one or optional vox) for an optimum transmission
quality. Adjustable level from 1 (high level) to 9 (low level)
by using channel selector switches (6).
the Sensitivity Level.
Anti-Vox : allows disabling the transmission generated by
-
the surrounding noise. The level is adjustable from 0 (Off)
to 9 (low level) by using channel selector switches (6).
corresponds to Anti-vox Level.
-
Delay time : allows avoiding the sudden cut of the trans-
mission by adding a delay at the end of speaking. The level
is adjustable from 1 (short delay) to 9 (long delay) by using
channel selector switches (6). corresponds to Delay Time.
9
/ Vox delay time . Press shortly •VOX (7)
corresponds to
Publicité
Table des Matières
