Parts Description - Makita EY402MP Manuel D'instruction

PARTS DESCRIPTION

2
1
1 Saw chain
4 Retaining nut
7 Guide bar cover
ASSEMBLY
CAUTION:
Always be sure that the motor is
switched off and the battery cartridge or the spark
plug cap is removed before carrying out any work
on the tool.
CAUTION:
Do not touch the saw chain with
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION:
The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
3
4 5
2 Guide bar
5 Chain adjusting screw
-
8 ENGLISH
6
3
6
- -
To remove the saw chain, perform the following steps:
1.
Loosen the chain adjusting screw, then the retain-
ing nut.
► 1. Chain adjusting screw 2. Retaining nut
2. Remove the sprocket cover, and then remove the
saw chain and guide bar from the tool body.
To install the saw chain, perform the following steps:
1. Check the direction of the saw chain. Match the
direction of the saw chain with that of the mark on the
tool body.
2. Fit one end of the saw chain on the top of the
guide bar. Fit the other end of the saw chain around the
sprocket. Make sure that the saw chain is properly fitted
on the sprocket and properly fitted in the groove of the
guide bar.
7
Oil tank cap
Front grip
-
2 1