HQ Power VDSCD3000 Notice D'emploi page 7

17. RELOOP BUTTON
If a loop has been made and you have hit the exit button, press this button to enter the loop again. To exit
loop press the out/exit button.
18. PLAY / PAUZE
Each press of the play/pause button causes the operation to change from play to pause or from pause to
play.
19. PITCH SLIDER
The pitch can be changed up to +/- 12% by pressing the button so the pitch LED is lit, then moving the
sliding fader. The pitch will not be changed if the pitch LED is off. If you want to change the BPM
adjustment range, press and hold the pitch button and press the pitch bend+ to select.
20. COUNTER BUTTON
Tap this button with the beat of the music to determine the current beats per minute (BPM)
21. RELAY
Press the relay button to enable relay function. While the relay is enabled, the LED will light. In single
mode, the CD playing will be paused at the next track when finishing playing current track. The other side
that is stand-by will start playing automatically.
22. BPM BUTTON
This button switches the mode of the display between showing the BPM and the percentage change in the
pitch.
d. Rear Panel Control Unit (fig. 4)
23. CONTROL SOCKETS
Via the control socket, the respective CD player can be remotely controlled. If you are using a mixer with
fader start function, connect the player with the control out socket. Please note that these sockets must
never be connected with any voltage.
24. CONTROL CONNECTOR
Connect the main unit here.
e. LCD (fig. 5)
1. ►
Lit while the unit is playing a CD.
VDSCD3000 7 HQ POWER