HQ Power VDSCD3000 Notice D'emploi page 10

• MEMORY BACKUP
This will automatically keep your last setting even if you unplug the CD player from the mains. It will also
memorize your cue point. Memory cues are erased automatically when a new CD is played or by holding
memory button pressed for 3 seconds.
• ERASE CUE POINT
To clear all the cue memory, just press and hold the memory button for 3 seconds.
• FADER START POINT
Connect the CD player to a mixer with cross fader.
• RELAY PLAY USING 2 PLAYERS
o Setting the relay function by connecting both players' control jack to each other without pressing the relay
button. When both players' control jack is connected to each other, the relay play effects can be produced.
Set both players to single mode.
Begin playback on the first player.
When the current playing track ends, playback will begin automatically on the stand-by player.
The first player will enter stand-by mode at the beginning of the next track on its disc.
By repeating this operation, the two players can be used to perform continuous relay play.
By loading new discs on the stand-by player, you can construct a continuous program.
By setting a cue point on the stand-by player, you can perform relay to any desired cue point on the
selected track.
o Setting the relay function by pressing the relay button on the front panel of the controller.
The default has no relay function when powered on.
Press the relay button to enable the relay function.
When the relay is enabled, the LED will light on.
In single mode, the CD player will be paused at the next track when it has finished playing current track.
Only the other side of the CD player that is stand-by will start automatically.
o Disabling the relay.
Press the relay button to disable the function.
The LED will go out when relay is disabled.
The fader start function can be used.
• STUTTER EFFECT
It can create a sound similar to a CD skipping. The stutter effect can be created in 2 ways.
o By rapidly pressing the cue button
Press play / pause button so that the music is playing. The play / pause LED will light.
Next, press the cue buttons synchronously with the music.
o By rapidly pressing cue buttons 1, 2, 3 or 4.
• REVERSE PLAY
Reverse play allows you to play a track, loop or sample backwards. This function is activated by pressing the
reverse button. This function will react differently to different playback modes.
o Reverse track / disc play
In this mode, the unit will playback reversely until the function is turned off. If the reverse function is not
turned off, the unit will to play the whole disc in reverse mode until it reaches the beginning of the disc.
When the unit comes to the beginning, it will automatically cue to the first track.
o Reverse loop play
In this mode, the loop will play reversely once and turn off. If the reverse function is turned off at this point,
the loop will continue in regular play. If the out / exit button is pressed during reverse playback mode,
reverse playback will continue until the button is released.
• BRAKE EFFECT
This effect simulates a turntable platter stopping quickly. To activate the function press the brake button.
• BRAKE EFFECT PARAMETERS
The parameters can be adjusted from 0ms to 9.9s. To adjust the effect parameters, press on the brake button.
Once the function has been activated, use the jog wheel to adjust. All parameters will return to their default
setting once the unit has been powered down.
VDSCD3000 10 HQ POWER