Connecting The Remote Control - Dometic Waeco CombiPower 2012 Instructions De Montage

_CombiPower_IA_DE-IT.book Seite 84 Freitag, 21. Oktober 2011 8:10 20
Connecting the device
Earthing the chassis
The metal housing of the device is connected internally to the neutral con-
ductor and must therefore be connected to the chassis of the vehicle.
➤ Connect the "CHASSIS GROUND" connection (fig. 1 9, page 3) to the
vehicle chassis with a low-resistance electrical conductor.

Connecting the remote control

➤ Plug one end of the remote control cable into the "LCM" connection
(fig. 1 13, page 3).
➤ Plug the other end of the remote control cable into the socket on the re-
mote control (fig. 4 13, page 4).
Connecting a PC
➤ Plug the Western connector of the RS-232 cable into the "RS-232"
connection (fig. 1 14, page 3).
➤ Plug the serial connector of the RS-232 cable into the PC socket.
Connecting the battery sensor
➤ Plug the battery sensor into the "BAT. TEMP." connection (fig. 1 15,
page 3).
➤ Attach the battery sensor to the housing of the battery (fig. 8 2, page 6).
The cable wiring is as follows (fig. 0, page 7):
Pin no.
1
2
3
4
5
6
84
Signal description
Not used
Earth
Battery sensor
Not used
Not used
Not used
CombiPower
EN