Dometic Waeco CombiPower 2012 Instructions De Montage page 64

_CombiPower_IA_DE-IT.book Seite 64 Freitag, 21. Oktober 2011 8:10 20
General safety instructions
CAUTION!
!
 Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
 Make sure that the device is earthed.
 Make sure that the lead has a sufficient cross-section.
 Lay the cables so that they cannot be tripped over or damaged.
 Fasten the cables securely.
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
NOTICE!
A
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or bushings to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Set up the device in a dry location where it is protected against
splashing water.
 Protect the device against corrosive fumes and salty or moist
air.
 Protect the device and the cable against rain and moisture.
 Ensure good ventilation.
 Only install the device indoors, never outside.
 Do not connect the 230 V output of the inverter to a different
230 V source.
64
CombiPower
EN