Power Saving Function; On/Off Timer Function - Sony PFM-42B1 Mode D'emploi

Controlling Power On/Off Automatically (Power Control Function)
C O N F I G ( 1 / 2 )
D I S P L A Y
W - V G A
C L O S E D C A P T I O N :
C O L O R S Y S T E M
Y U V L E V E L
S C R E E N F I L L
P O W E R C O N T R O L
S C R E E N S A V E R
S E L E C T S E T
3
Press v / V to move the cursor (B) to "POWER
CONTROL" and press ENTER.
The following menu appears on the display panel.
P O W E R C O N T R O L
E N E R G Y S A V I N G
P O W E R S A V I N G
O N / O F F T I M E R
S E L E C T S E T
4
Press v / V to move the cursor (B) to "ENERGY
SAVING" and press ENTER.
The following menu appears on the display panel.
E N E R G Y S A V I N G
5
Press v / V to select the ENERGY SAVING
mode ON/OFF.
OFF: No energy saving
ON: Energy saving
By enabling the ENERGY SAVING (ON), the
screen brightness is reduced and you can view the
display unit while saving energy.

Power Saving Function

1
In the CONFIG (1/2) menu, press v / V to move
the cursor (B) to "POWER CONTROL" and press
ENTER.
40
(GB)
: O N
: O F F
O F F
: A U T O
: S M P T E
: C E N T E R
ENTER E N D MENU
: O F F
: O F F
: O F F
ENTER E N D MENU
: O F F
The following menu appears on the display panel.
P O W E R C O N T R O L
E N E R G Y S A V I N G
P O W E R S A V I N G
O N / O F F T I M E R
S E L E C T S E T
PFM-42B1/42B1E: "ENERGY SAVING" is not displayed.
2
Press v / V to move the cursor (B) to "POWER
SAVING" and press ENTER.
The following menu appears on the display panel.
P O W E R S A V I N G
3
Press v / V to select the length of time until the
change to power saving mode.
OFF: The power saving function does not work.
5min: Changes to the power saving mode after
five minutes if there is no input signal.
10min: Changes to the power saving mode after
10 minutes if there is no input signal.
The ON indicator flashes when the unit is in the
power saving mode.
To cancel the power saving function
• Input the sync signal again.
• Press the 1 (standby) switch on the 1 (standby)
switch / indicator section or the POWER ON switch
on the Remote Commander.
Signal specification for using the power
saving function
The sync signal should be the RGB signal input to the
13th pin of the RGB/YUV (D-sub 15-pin) connector
in the INPUT 1 or INPUT 2 connectors.

On/Off Timer Function

1
In the CONFIG (1/2) menu, press v / V to move
the cursor (B) to "POWER CONTROL" and press
ENTER.
: O F F
: O F F
: O F F
E N D
ENTER MENU
: O F F