Technical Information - IKEA SKINANDE Manuel D'utilisation

ENGLISH
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a different
brand or activate the rinse aid dispenser
and use rinse aid together with the combi
detergent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.
Activating the rinse aid dispenser with the
multitab function activated
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PROGRAMME'.

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.
2. Press and hold function buttons (B) and
3. Press function button (B).
4. Press function button (B) to change the
5. Deactivate the appliance to confirm the
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
(C) at the same time until the indicators
of function buttons (A), (B) and (C) start
to flash.
• The indicators of function buttons (A)
and (C) go off.
• The indicator of function button (B)
continues to flash.
• The display shows the setting of the
rinse aid dispenser.
setting.
setting.
596 / 818 - 898 / 555
(0.5 / 0.05 ) / (8 / 0.8 )
2)
16
Off
On
220-240 V
50 Hz
max. 60 °C
12
0.99 W
0.10 W