Swing Guard - Munchkin brica Wood and Steel Notice D'installation

How to Install
MOUNTING YOUR GATE
Place the gate where you want to install it, then extend all four adjustment rods until they
1.
reach the walls. Ensure that the ends of the adjustments rods are seated inside the cups.
≤2.5˝
Turn the adjustment rod nuts with your hand until they are snug. Use the wrench to tighten
2.
the nuts on the threaded adjustment rods until the gate is secure. The nuts should be
tightened until the gate latch locks into the frame.
To keep the gate an equal distance from both walls, tighten each
nut a little at a time and alternate between all 4 corners. DO NOT
overextend the adjustment rods. If the gate is more than 2.5 inches
from the wall, you must add an extension.
10

SWING GUARD

Determine which direction you want the
gate to swing open. Rotate either wing
of the swing guard down to prevent
the gate from opening in the opposite
direction, or leave them both up to open
the gate in both directions.
OPENING YOUR GATE
Squeeze the button on the side of the
≤2.5˝
handle. Push the handle downward to
swing the gate open in either direction.
CLOSING YOUR GATE
Your gate has an easy close feature. You
can leave the gate in the open position
and when ready, simply push the gate
door closed until it clicks.
Always check the handle to make sure
that the gate is securely locked and never leave your child unattended.
CLEANING YOUR GATE
Use mild soap and wipe with a damp cloth.
How to Use
11