Gate Placement - Munchkin brica Wood and Steel Notice D'installation

How to Install

GATE PLACEMENT

This gate is approved for use at the bottom
of stairs, as well as in doorways, hallways
and entryways. The gate must be installed
between two structurally sound surfaces.
Do not use this gate in any location without
using all 4 wall cups, sticky pads, and
screws provided when installing the gate.
In some openings only 2 top wall cups can
be fitted.
If you are installing the gate at the bottom of
the stairs, we recommend placing it on the
floor below the first step. If the gate must be
placed on the lowest stair, position it toward
the front of the step. Be sure that the gate is
resting on the floor. The gate should NOT be
raised above the floor ≥5mm.
8
WALL CUPS
Place the wall cups on the ends of the adjustment rods.
1.
2. Temporarily place the gate where you want to install it,
flush with floor. Pull the adjustment rods out until they
reach the walls and trace the position of each wall cup
with a pencil.
Retract the adjustment rods and set the gate aside
3.
for now.
FOR DRYWALL WITHOUT STUD/ PLASTERBOARD: Hold
4a.
the wall cups in position and mark the center with a
pencil. Then put the cup aside and drill a 7/32" hole into
the drywall at the center mark. Insert a drywall anchor.
FOR DRYWALL WITH STUD: Hold the wall cups in
4b.
position and mark the center with a pencil. Then put the
cup aside and drill a 5/64" hole into the drywall at the
center mark.
5. Peel the backs off the sticky pads and attach them to
the flat side of the the wall cups. Then stick the wall
cups back onto the wall to fit your pencil marks.
Secure the wall cups against the wall with screws.
6.
• FOR DRYWALL WITHOUT STUD/ PLASTERBOARD:
Use screwdriver or drill to insert screw into center
of wall cup. The screw will go through the attached
sticky pad and into the wall anchor previously
inserted in step 4a.
• FOR DRYWALL WITH STUD: Use screwdriver or drill
to insert screw into center of wall cup. The screw will
go through the attached sticky pad and into the hole
previously drilled in step 4b.
How to Install
2
4a. Without Stud
7/32"
4b. Stud
5/64"
9