Architect Series Custom Side Panels - KitchenAid Architect Série Guide D'installation

3-Piece Grille Overlay Panel Configuration
Top View
¹ ₂
A. " (1.27 cm) Decorative
overlay panel
¹ ₈
B. " (3.18 mm) Spacer panel
¹ ₄
C. " (6.25 mm) Backer panel
3-Piece Door Overlay Panel Configuration
1"
(2.54 cm)
A
A. Offset dimension
¹ ₄
B. " (6.25 mm) Backer panel
¹ ₈
C. " (3.18 mm) Spacer panel
³ ₄
D. " (1.92 cm) Decorative overlay panel
1-Piece Overlay Panel Configuration
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimesions and placement instructions to be sure that the
custom overlay panels will fit properly.
®
Architect Series Custom Side Panels
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed and the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
may not reflect the needed panel installation dimensions.
The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick
to prevent warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on the rear wall.
Side View
A
B
C
1"
(2.54 cm)
¹⁄₂
"
(1.27 cm)
B C D
Refrigerator
¹⁄₈
24 "
(61.3 cm)
¹¹⁄₁₆
23 "
(60.3 cm)
¹⁄₂
23 "
(59.7 cm)
Side Trim
¹⁄₄
(6.35 mm)
³⁄₁₆
"
(4.7 mm)
⁷⁄₃₂
"
(5.5 mm)
¹³⁄₃₂
" (10 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add ⁷⁄₃₂" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than ¹⁄₄" (6.35 mm) thick, route the front
edge to allow the side panel to fit into the trim.
A
Flush Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall.
2. Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.
A
"
¹¹⁄₆₄
"
(4.5 mm)
⁵⁄₈
"
(15.7 mm)
11