boso medistar S Mode D'emploi page 55

Measurement display
Invalid measurements with an 'Err'
message (see page 58) are not stored.
If the symbol '
measurement, it is recommended that
the measurement is repeated, holding
the arm completely still.
If the ' ' symbol appears again
even with the arm held still, this may be
an indication of an irregular heartbeat.
Please discuss this with your doctor at
your next visit.
Blood pressure is a dynamic parameter
and can be affected by the patient's po-
sition, e.g. sitting, standing, lying, mo-
ving, before or during the measurement
as well as by his physical condition
(stress, disease, etc.).
' appears after the
➡ If the measurement result is obvio-
usly wrong, repeat the measure-
ment.
The unit switches itself off automatically
after about 1 min. To repeat a measure-
ment, press the 'START' button again.
Allow at least two minutes
2
min
between measurements.
➡ If no further measurement is requi-
red, remove the unit from the wrist.
55