Ironing Recommendations - SOLAC PV1610 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
TEMPERATURE SELECTION (fig. 4)
1 Turn the temperature selector (7) to the desired position.
)
When changing the position of the temperature selector (7), either to increase or
decrease the temperature, the iron will take several minutes to reach the set
temperature.
)
Once the temperature has been reached the heating light turns off (9).
STEAM SELECTION
,
To obtain steam the temperature selector (7) must be situated between the levels • •
and max, depending on the garment to be ironed.
The soleplate has 2 steam positions (dry ironing
1 When the pilot (9) goes off, indicating that it has reached the desired temperature, set
the steam switch (8) to the ironing with steam position if desired.
EMPTYING THE WATER TANK
)
After ironing always empty the water tank.
1 Set the steam selector (8) to the closed position
to the min position.
2 Unplug the cord from the power supply.
3 Open the water filling inlet (4) and place the iron upside down over the sink, shaking
gently to completely empty out all the water.
4 Wait until the iron is completely cool and store upright in a safe place.

IRONING RECOMMENDATIONS

IRONING WITH STEAM
,
To obtain a professional finish, we recommend ironing with steam first and then dry
ironing so clothes are not damp.
STEAM BOOSTER (Fig. 5)
)
When using steam to iron and more steam is required, press button (6) two or three
times and direct the steam booster to the desired area of the garment, and then pass
the sole plate to dry. This function is useful for eliminating creases.
• We recommend pressing the knob at 5 second intervals.
VERTICAL STEAM (Fig. 6)
)
Allows creases to be removed from delicate fabrics without the need to use the ironing
board: jackets, coats, curtains, etc.
1 Fill the water tank as described in the section "BEFORE YOU START IRONING."
2 Place the garment on a hanger, away from other garments, people, items, animals, etc.
n
Do not project the steam at a garment hanging in a closet or if someone is wearing it.
3 Set the steam selector (8) to the closed position
to the max position.
4 Move the iron towards the garment vertically (between 15 and 30 cm) and press the
steam button (6) only once. Do not hold the iron over the garment too long as this may
cause damage.
5 Wait a few seconds before pressing the button (6) again, to avoid damaging the
garment. Most creases can be removed with three shots of steam.
14
; or ironing with steam
and the temperature selector (7)
and the temperature selector (7)
IRONING RECOMMENDATIONS
)

Publicité

Table des Matières
loading

Table des Matières