EUROM Force 1218 Ash Cleaner Metal Manuel D'instruction page 31

 While using the device, constantly check the
heating of the device and the suction hose.
 When the device is used as a blower, the hose can be used with or without the
metal nozzle.
 To reduce the risk of hearing damage, wear hearing protectors for prolonged use
of the device.
 When using the blow function, be extra careful:
- Keep bystanders/spectators away to prevent injury.
- Wear a dust mask if blowing causes dust that can be inhaled.
Caution: The HEPA filter must fully depress the white switch on the engine block
otherwise the device will not work. (See label on the bottom of the motor cover
(3).)
After use: cleaning and maintenance
Empty the boiler of the device before and after each use and clean it, to prevent
materials from collecting in the boiler that present a fire hazard.
 Switch the device off with the on/off button (2).
 Remove the plug from the socket.
 Roll up the electrical cable.
 Open both clamps (10) and remove the motor cover (3) from the boiler (5).
 Empty the boiler. Remove the dirt from the boiler and clean the boiler. If you need
to use water, dry it thoroughly!
 Clean the filter. Pull the HEPA filter from the motor block (A) and clean it: clean
the outside with a different vacuum cleaner (B) and the inside, if necessary with
a hand sprayer (C). Never clean the outside with water (D), because then the dirt
will be forced in! Do not use any aggressive or abrasive cleaning agents and allow
the HEPA filter to dry thoroughly before replacing it. Finally, slide the HEPA filter
firmly back into place: the white switch on the bottom of the engine must be
pressed by the HEPA filter.
Caution: The device will not work without a properly installed HEPA filter!
 Replace the motor cover (3) on the boiler (5) and close both clamps (10).
31