EUROM Force 1218 Ash Cleaner Metal Manuel D'instruction page 26

etc. are kept. Do not use the device in a flammable environment
such as near gas tanks, gas pipes, paint and dust mist or spray
cans. This creates an explosion and fire hazard!
11. When setting up the device, make sure to place it on a safe and
solid surface.
12. The device is suitable for extracting cold ash from fireplaces, wood
or coal stoves, ash drawers and grills. Ash with a temperature
higher than 40°C must never be vacuumed! Cold ash has had
sufficient time to cool down and contains no glowing embers, hot
residues or objects in which the fire has not been completely
extinguished; check through the ash (using a metal tool) on it
before you start vacuuming! Cold ash no longer produces palpable
heat.
13. Only vacuum ash from conventional and approved
fuels.
14. Do not use this device for vacuuming out (gas) boilers or oil-fired
heating equipment.
15. Empty the boiler from the appliance before and after each use and
clean it, to prevent materials from collecting in the boiler that
present a fire hazard.
16. Do not vacuum up soot or flammable substances.
17. The following objects and/or substances may not be vacuumed
up with the device:
 Burning, smoking, smoldering or hot objects/substances such as
hot ash, glowing cigarettes, matches, etc.
 Toxic, corrosive or harmful substances: this device is not
approved for vacuuming/separating the dangerous
substances from dust class L, M and H.
 Water or other liquids.
 Objects that are too large.
 Sharp objects such as shards, nails, etc.
 Volatile substances, flammable gases, acids, waste that poses an
explosion hazard, etc.
 Hazardous substances such as asbestos etc.
 Highly flammable substances such as gasoline, gas oil, etc. Do
not use the device in a room where these substances are or may
be present.
 Flour, cement dust, calcareous, gypsum or graphite powder, etc.:
this can obstruct ventilation, damage the motor and cause
overloading.
26