Listening To Music; Making A Phone Call - Panasonic RP-HF400B Manuel D'utilisation

Listening to music

If the Bluetooth compatible device supports the "A2DP" and "AVRCP" Bluetooth
®
profiles, music can be played back with remote control operations on the unit.
• A2DP (Advanced Audio Distribution Profile): Transmits audio to the unit.
• AVRCP (Audio/Video Remote Control Profile):
Allows remote control of the device using the unit.
1
Connect the Bluetooth device and the unit (→ P. 4)
®
2
Select and play the music on the Bluetooth
• The selected music is output to the speakers of the unit.
Operating time of battery
Battery type
Rechargeable battery (installed in the unit)
Operating time may be less depending on the operating conditions.
■
Attention
• The unit might leak sound depending on the volume level.
• When the volume is increased to near maximum level, music may sound
distorted. Decrease the volume until the distortion is cleared.
Remote controlling
You can control the Bluetooth ® device using the unit.
• Depending on Bluetooth ® devices, some functions below do not work, or work
differently via operation of the unit.
(Operation example)
Play/Pause/Call
Press Play/Pause/Call
Previous/Next/Volume
Press Increase the volume
+
Forward to the start
Press and hold
of next track
Decrease the
Press
volume
−
Return to the start of
Press and hold
current track
■
Note
• The volume can be adjusted in 15 levels.
When the maximum or minimum volume is reached, a beep will sound.
®
® device
Operating time
Approx. 20 hours
Play/Pause/Call
Volume –/ Volume +/
Previous Next

Making a phone call

With Bluetooth ® enabled phones (cell phones or smartphones) that support the
"HSP" or "HFP" Bluetooth profile, you can use the unit for phone calls.
®
• HSP (Headset Profile):
This profile can be used to receive monaural sounds and establish two-way
communication using the microphone on the unit.
• HFP (Hands-Free Profile):
In addition to the HSP functions, this profile has the incoming and outgoing calls
function.
• Connect the Bluetooth ® enabled phone and unit (→ P. 4)
1
When answering an incoming call
Press Call on the unit
and answer the call
• During an incoming call,
ringtone will sound from the
speaker and the LED will blink.
• (HFP only) To reject the
incoming call, press Call
twice quickly.
Call
2
Start talking
• The LED will repeatedly blink 2 times during a call.
• The volume can be adjusted during a phone call. For setting instructions, see
page 5.
3
Press Call to end the phone call
• A beep will sound.
When making an outgoing call
Make an outgoing call on
the Bluetooth enabled
®
phone
• Also refer to the operating
manual for the Bluetooth ®
enabled phone.
(Checking and operation steps on the
unit are explained below)
• During an outgoing call, ringtone
will sound from the speaker and
the LED will blink.
• To cancel the outgoing call,
press Call .
A beep will sound.
• (HFP only) When the phone is
idle, press and hold Call for
approximately 5 seconds. An
outgoing call will be made to the
last dialed number. One short
click will sound from the speaker
and the LED will blink.
5
5