Connecting A Bluetooth Device - Panasonic RP-HF400B Manuel D'utilisation

Connecting a Bluetooth
Preparation
• Place the Bluetooth ® device within approx. 1 m (3.3 feet) from the unit.
• Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
connection
1
In the power-off state, press and hold the power button of this
unit until the LED blinks
When pairing a device for the first time
When pairing a second or subsequent devices : approx. 5 seconds
• The unit starts to search for the Bluetooth
LED will blink in blue and red alternately.
2
Turn on the power of the Bluetooth
Bluetooth ® function
3
Select "RP-HF400B" from the
Bluetooth device's menu
®
• The MAC address "□□□□□□" ("□" stands for a
character that is unique to each set.) may be
displayed before "RP-HF400B" is displayed.
• If prompted for a passkey, input the passkey
"0000 (four zeros)" of this unit.
4
Check the connection with the
Bluetooth ® device on the unit
• The LED will blink in blue and red alternately until the connection
with the device is completed. When the LED (blue) blinks twice
every approx. 2 seconds, pairing (registration) is completed.
(Connection established)
■
Note
• If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again.
• 2 or more Bluetooth ® devices cannot be registered to the unit at the same time.
• You can pair up to 8 Bluetooth
®
the device with the oldest connection will be replaced. To use it, perform pairing
again.
4
4
device
®
device for
®
: approx. 3 seconds
® device for connection, and the
unit, and enable the
®
(Ex.)
Bluetooth
Bluetooth
Device
RP-HF400B
devices with this unit. If a 9th device is paired,
Connecting a paired Bluetooth
1
Turn on the unit
• Press and hold the power button of this unit for approx. 3 seconds until the
LED (blue) blinks.
• A beep will sound, and the LED (blue) will blink slowly.
2
Perform steps 2 and 3 of "Pairing (Registration) this unit with the
Bluetooth
®
• When the LED (blue) blinks twice every approx. 2 seconds, pairing
(registration) is completed. (Connection established)
■
Note
• This unit remembers the device lastly connected. Connection may be
automatically established after step 1 (See above).
• If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again. (See the left page)
ON
Select
® device
device for connection" (See the left page)