De-Dust And Clean Collection Receptacle; Material Damage - Abicor Binzel TSi Mode D'emploi

TSi injection unit

9.2 De-dust and clean collection receptacle

Carry out each step in accordance with the figures below:
1
5
4
B
C
3
1 Device cover
2 Bayonet closure
Fig. 10 Maintenance and cleaning
1 Unscrew the device cover (1) using the bayonet closure (2). Remove pressure flange (5) and collection
receptacle (4).
2 Empty collection receptacle (4).
3 Clean injection nozzle if necessary: 9.3 Clean the injection nozzle on page EN-16
NOTICE
• Ensure that the sealing surfaces between the device cover (1) and the pressure flange (5) are clean
 Replace the rubber seal if necessary. 9.4 Replace rubber seal on page EN-17

Material damage

Using the incorrect release agent can damage the TSi injection unit.
• Only operate the TSi injection unit with original ABICOR BINZEL release agent.
• Only operate the TSi injection unit with original collection receptacle.
4 Remount all parts in the reverse order.
A
D
3 Injection nozzle
4 Collection receptacle
and undamaged. Replace the rubber seal if necessary.
CAUTION
9 Maintenance and cleaning
2
5 Pressure flange
EN - 15