Eschenbach VarioLED flex Mode D'emploi page 7

i Plastic screws for adjusting ease of
movement
Setting Up
1. Screw the table clamp y of the magni-
fying glass light to a table top.
2. Insert the flexible arm r into the
hole in the table clamp y. The ease
of movement is adjusted using the
plastic screw t. Do not over-tighten
the screw, otherwise the thread of
the adjusting screw will be damaged.
The screw is not designed for provid-
ing a secure connection between the
flexible arm and the table clamp and
therefore preventing the table clamp
from falling off the flexible arm.
3. Plug the wall plug transformer u into
a properly connected power socket.
This should be done using an AC
adapter (provided) that is suitable
for your country (EU, GB, USA) which
has been previously inserted into the
wallplug transformer u.
4. Switch on the light using the on/
off switch e on the handle. A slight
amount of heat generation in the
vicinity of the illuminated LEDs is
normal.
5. Select the intensity of the light using
the small changeover switch q - full
ring light (figure
ring segment light only ( ). The seg-
ment light makes it easier to recog-
nise surface structures.
6. Set the magnifying glass light to the
required working height using the
flexible arm r. The top of the magnify-
ing glass can be rotated in the direc-
tion of the arm axis. The lens can also
be swivelled by 90° in relation to the
arm axis with ring light w (figure
pg. 2). The ease of movement can be
adjusted using the plastic adjusting
screws (i). Do not over-tighten the
on pg. 2) or rear
on
screws, otherwise the thread of the
adjusting screws will be damaged.
7. In order to switch the device off, press
the on/off switch e on the handle.
8. To disconnect the device from the
power supply, unplug the wall plug
transformer u from the socket.
Care Instructions
Pull the wall plug transform-
er out of the socket before
cleaning!
Clean the housing and arm with a damp
cloth. Clean the lens w with a soft, lint-
free cloth (e.g. glasses cleaning cloth). In
case of heavy soiling (e.g. fingerprints),
clean the lens w carefully with a damp
cloth.
Do not use any soap solutions that
contain softening agents, alcohol-based
solvents or abrasive cleansers! These
could destroy the lens w.
Technical Data
Item no.
Arm length
Lens diam.
Thickness
Primary voltage
Secondary voltage
Power consump-
tion
X Illumination strength:
Ring light: approx. 6000 lx in 150
mm
Segment light: approx. 3000 lx in
150 mm
X LED class 1 EN 60825-1:2002
X Minimum permissible bending
radius of flexible arm: 65 mm
X cera-tec ® lens, hard coated
- 7 -
2781 27815
350 mm 565 mm
80 mm
6 dpt
110 V — 230 V
24 V
approx. 5 W