Device Operation; Operating Modes; Park Mode; Command Mode - ADEUNIS Sigfox MOTION V2 Guide Utilisateur

Sigfox MOTION V2 - Guide utilisateur / User guide version V2.0.1

2. DEVICE OPERATION

2.1. Operating modes

IMPORTANT NOTE: adeunis® uses the Big-Endian data format
The device has several operating modes
FR
EN
MODE COMMANDE

2.1.1 PARK MODE

The device is delivered in PARK mode, it is thus in standby mode and its consumption is minimal. Exit PARK mode by pressing and holding the
button for more than 5 seconds. The green LED lights up to indicate the detection of the pressed button and then flashes rapidly during the
device start-up phase.
The device then sends its configuration and data frames.

2.1.2 COMMAND MODE

This mode is used to configure the device registers. There are two ways to enter this mode:
- Open the adeunis® IoT Configurator application, connect a cable to the device's micro-USB port and connect it to the computer or
mobile phone.
- Connect a cable to the micro-USB port of the device and enter command mode via an AT command.
The output of the COMMAND mode is via the ATO command or the USB cable disconnection. The device will then return to its previous mode,
i.e. PARK or OPERATING

2.1.3 OPERATING MODE

This mode allows the device to work in its intended end use.

2.1.4 Low battery management

When the product detect that the battery is not able to deliver the level of power required for a emission (extreme temperature or end-of-life of
the battery), it waits to be able to transmit. If it detect that the generated delay is longer than 1 minute, it informs the user activating the "low
battery" flag in the status byte of each frame sent.
The product have
to sent a frame
The "battery low" flag is automatically disappearing when the battery is replaced or when temperature conditions are favorable to the proper
functioning of the battery.
Command send-
ing by serial link
Auto adaptation
(cf Low battery
management)
yes
Product wait
no
Enough pow-
to be able to
er to send a
transmit
frame ?
MODE PARC
Long press on the
button >5s
MODE EXPLOITATION
Information sent if
battery low
SHUT-DOWN
(no battery)
yes
Delay lower
no
than 1 minute
?
Battery replaced
"low battery"
no no
appeared in
send the frame
status byte
The product
Page 36 of 46