Daily Alarm Sub Mode; How To Set The Daily Alarms; Stopwatch Sub Mode - Suunto MARINER Guide De L'utilisateur

3.2 DAILY ALARM SUB MODE

The Wristop Computer allows the user to select and enter settings for up to three alarms.
In the TIME mode, PRESS the [Select] button once to enter this sub mode.
In the Daily Alarm sub mode (Fig. 10):
• Field 1 displays "ON" or "OFF" (the activation status of a particular alarm),
• Field 2 displays the time of a particular alarm, and
• Field 3 displays the alarm (1, 2, or 3) the user is viewing.
Pressing the [+] or the [-] button will toggle between the alarms 1, 2, or 3 to view the settings for each alarm.

3.2.1 How to Set the Daily Alarms

1. PRESS the [+] or the [-] button to select the desired alarm to be set (1, 2, or 3).
2. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, the "ON" or "OFF" will begin to flash.
3. PRESS either the [+] or the [-] button to toggle between "ON" and "OFF".
4. At the setting desired, PRESS the [Select] button to move to the next setting. Located in the center of Field 2, the hour
will begin to flash.
5. PRESS the [+] button to scroll the hour upward or PRESS the [-] button to scroll the hour downward.
6. At the hour desired, PRESS the [Select] button to move to the next setting. Located on the right of Field 2, the minutes
will begin to flash.
7. PRESS the [+] button to scroll the minutes upward or PRESS the [-] button to scroll the minutes downward.
8. At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program. A small bell will
appear at the bottom left side in Field 2 to signify an alarm has been activated.
The Alarm setup is complete. To activate up to three alarms, please repeat steps 1-8 for the selected alarm (1, 2, or 3).

3.3 STOPWATCH SUB MODE

The Wristop Computer stopwatch sub mode can provide split time measurement and two finish times up to 24 hours. In
the TIME mode, PRESS the [Select] button twice to enter this sub mode.
15