Troubleshooting - Scheppach BCH3300-100PB Traduction Du Manuel D'utilisation Original

13. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault
The equipment does
not start
The equipment starts
but does not develop its
full power
The engine does not
run smoothly
Engine smokes
excessively
If the temperature of
machines is too high
28 GB
Heruntergeladen von manualslib.de
Possible cause
• Correct starting procedure not followed
• Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
• Incorrect choke lever setting
• Soiled air fi lter
• Incorrect carburetor setting
• Cutting blade blunt
• Incorrect electrode gap on the spark plug
• Incorrect carburetor setting
• Incorrect fuel mix
• Incorrect carburetor setting
• Engine is overloaded
Handbücher-Suchmachiene
Remedy
• Follow the instructions for starting
• Clean the spark plug or replace it with a new one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
• Set the choke lever on the
• Clean the air fi lter
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
• Clean the spark plug and adjust the electrode
gap, or fi t a new spark plug
• Contact an authorized customer service outlet
• Use the correct fuel mix (see fuel mixing table)
• Contact an authorized customer service outlet
• Insure the machines have rest at regular time
position