Lega DAISY Guide D'instructions page 15

2.1 HANDLING / TRASPORT
The uncapping machine weighs more than 30 kg, it cannot therefore be lifted or handled manually by a single
person.
2.2 INSTALLATION
The machine comes equipped with an approx. 3m long connecting cable ready to be plugged into a 220V
50Hz single-phase current outlet.
Have a competent electrician test the continuity of the line: phase-brown, neutral-blue, yellow-green-earth.
The cable should only be plugged into an electric socket up to safety standards. The connecting value is
1600w. Do not use multiple plugs.
For extra safety, always provide a differential switch with 30mA release current upstream from the machine;
the electric line must be protected by a 16A automatic valve.
To ensure correct operation, place the uncapping machine onto a solid bench-type uncapping tray fitted with a
tank of minimum dimensions 1250x480mm, and two baskets for collecting cappings.
Always make sure that the machine is perfectly balanced and stable.
Always make sure that the power cable does not hinder other operations and above all, do not imply a risk of
stumbling in the passage areas for workshop operators.
The machine should be washed, before use, with water and a mild detergent, paying attention not to direct the
water jet towards the knives heating resistances.
2.3 DESCRIPTION
The uncapping machine consists of a main structure, a feed unit, a cutting assembly, a cell opening system,
an electrical control unit, protective guards.
The main structure and all components coming in contact with honey, are made of AISI 304 stainless steel,
food-grade or other treated materials in compliance with standards in force.
The feeding movement is achieved by means of a chain that driven by a gearmotor, runs on a guide rail. Three
drive rollers are present along the conveyor and alternately feed the frame. The chain movement is controlled
by a microswitch which is actuated by the presence of the frame. After the uncapping operation is complete,
the frame is held at the output position by a presser for recovery by the operator.
The correct position of the frames corresponding with the knives, is given by 4 adjustable guides. Frames are
correctly placed on the chain by means of two adjustable supports.
The cutting unit includes two knives set at an adjustable distance.
Heating is achieved by means of two 630 W resistors, one for each knife, inserted into the knife itself.
The temperature sensor is placed in one of the two knives.
Oscillation is achieved by means of a reciprocating movement produced by a gearmotor. Antifriction bearings
ensure proper axle shaft sliding.
The control unit is used to control all the movements of the machine, turn it on and off and adjust the
uncapping knive temperature.
A special device is provided next to the knives, made up of two opposing rotary blades that are used for
uncapping cells under the frame wooden borders.
This latter function can be adjusted or even disabled depending on the amount of cappings on the frame.
LEGA
srl
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
15 / 53