Publicité
Les langues disponibles
Les langues disponibles
When a large vehicle engine demands higher output than one
pump can provide, install two pumps in parallel as shown in
Drawing.
Outlet pipe
Carburettor
Caution
Check the electrical system of the vehicle for voltage and polari-
ty, and the needle pressure of carburetor. It will be a cause of fuel
overflow, if the outlet pressure of the Pump is stronger than the
needle pressure of carburetor.
Install the pump correctly according to the voltage and polarity
stamped on the pump. Otherwise, it will not function properly.
Wiring and tubing
1) Use 2 meter (6.5 feet) wire supplied by you to connect the
pump wire to the ignition-switch side terminal of the fuse box,
or between the ignition-switch and the ignition-coil.
2) Connect the hose to the pipe and use pipe cramp to fix securely.
3) Ground the pump securely.
Inlet
pipe
– 15 –
Outlet pipe
Publicité
