Operation - Schwamborn OES 430 Traduction Du Manuel D'utilisation Original

EN OES 430
Translation of the original operating instructions

3 Operation

High-voltage electrical current can be fatal!
Only connect the machine to power supplies
equipped with a residual-current device!
Connections with mains cables
must be protected from splash water!
Mains cables and power plugs must undergo a
functional safety check prior to start-up!
Risk of injury and fire due to defective electrical
cables!
Only suitably knowledgeable, qualified
professional electricians may perform work on
any electrical parts of the system!
When working on the machine (set-up,
maintenance, service, repair, cleaning, etc.), the
power supply of the machine has to be
disconnected from the mains
(Pull the power plug out of the power socket)!
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking or smoking at the workplace is
prohibited! Always eat in break rooms or
canteen areas!
A general inspection of the machine must be
conducted before starting up the machine! Pay
particular attention to damaged or loose
components, and to wear!
The machine may only be put into operation if it
is in perfect technical condition!
Adding to or modifying the machine in any way
that could compromise operating safety is
prohibited!
Cleaning and maintenance may be done only by
trained personnel according to the operating
manual.
Do not operate the machine in areas where
there is risk of explosion or where flammable or
hazardous materials are present!
After completing the work, thoroughly clean
yourself!
16
3 Operation
Risk of injury from parts flung out during
grinding work!
Wear protective clothing and protective goggles!
Wear safety shoes!
Wear protective gloves!
Proceed with special care and caution!
Risk of injury from dust formation during
grinding work!
Connect an extractor unit to the machine or feed
in water during the grinding process.
Wear respiratory protection!
Risk of injury from loud noise during grinding
operation!
Always wear hearing protection during the
grinding work!
Risk of injury from vibrations!
When working with brushes or grinding wheels,
the average hand-arm
vibrations can exceed 2.5 m/sec².
The working hours of the operator must be limited
according to national and international guidelines.
The operator must be independently proactive
here in protecting their own health.