Denon DJ SC6000 PRIME Guide D'utilisation page 14

Syncing & Pitch Adjustment
To activate sync, press Sync on the unit that you want to control the BPM, which becomes the "primary." After
Sync is activated on that unit, press Sync on any additional units. The tempo of each unit will immediately
synchronize to match the tempo of the primary unit.
The Sync state icon in the display will indicate the current status:
Sync Off: Sync is deactivated.
Tempo Sync: Only the tempo is synced (the BPM will match that of the primary unit).
Bar/Beat Sync: The tempo will be synced, and the track will be automatically bar- or beat-matched with
the track on the primary unit, depending on the Sync Mode setting.
To deactivate sync on an SC6000 PRIME unit, press and hold Shift and press Sync.
To set a different SC6000 PRIME unit as the primary, press Master. All connected units with Sync activated will
use the tempo of this unit. You can also tap Sync Lead on the touchscreen to select which layer on the primary
unit is used for sync.
To adjust the track's pitch, move the pitch fader. You can do this only when the deck is not synced.
Important: If Sync is activated, moving the pitch fader on the "primary" SC6000 PRIME unit will change the
speed of all synced units, while moving the pitch fader on other units will do nothing.
To adjust the track's pitch momentarily, press and hold one of the Pitch Bend –/+ buttons.
To adjust the range of the pitch fader, press and hold Shift and press one of the Pitch Bend –/+ buttons to
select +4%, 8%, 10%, 20%, 50%, or 100%.
To reset the track's pitch to 0%, press and hold Shift and press Key Lock/Pitch Reset. The track's pitch will
return to its original pitch (0%) regardless of the position of the pitch fader.
To adjust the track's key, tap the key on the touchscreen to open the Key Change Menu.
Pad Modes
The 8 pads have different functions in each pad mode. The Parameter / buttons will make adjustments specific to
each pad mode.
To enter each pad mode, press the corresponding button: Hot Cue, Loop, Roll, or Slicer.
Hot Cue Mode
In Hot Cue Mode, you can use each pad to jump to an assigned hot cue point.
Tip: You can use the Engine DJ software to set, name, and assign colors to your hot cue points. The names and
colors will appear in the display for reference.
To assign a hot cue to a pad, press a dimly lit pad at the desired location in the track. The pad will light up when
a hot cue point is assigned.
To jump to a hot cue point, press the corresponding pad.
To clear a hot cue from a pad, press Shift and the desired pad. The pad will turn off when there is no hot cue point
assigned to it.
14
Hot Hot Hot
Cue 1 Cue 2 Cue 3
Hot Hot Hot
Cue 4 Cue 5 Cue 6
Hot Hot
Cue 7 Cue 8