Optional Swing Attachment - elero Picolo XL Instructions De Montage

Installation
4.3.2

Optional swing attachment

The optional swing attachment is clamped to the housing tube.
When installing it, note that the pins are aligned in line with the piston end at-
tachment.
The swing attachment can be spread slightly for adjustment on the housing tube
by screwing in a screw into the centre thread. This screw must be slackened off
before tightening the clamping screws and must not be under pressure.
The clamping screws must be tightened alternately. Repeat this procedure until
the tightening torque of 6 Nm has been reached with both screws.
Clamping the swing attachment may result in pressure marks on the surface of
the housing tube.
Fig. 2
The swing attachment can be ordered as part number 750440901.
20
Swing attachment